However, the use of ring buoys and skiff are required.However, if you use a continuous fall protection system (without exception) to prevent employees from falling into the water, the use of USCG approved life vests is not required. So that is great that you already have that prepared. The use of USCG approved life vests are what is required by OSHA regulations.Each employee on a walking/working surface (horizontal or vertical) with an unprotected side or edge which is 6 feet (1.8 m) or more above a lower level shall be protected from falling by the use of guardrails systems, safety net systems, or personal fall arrest systems. When working above water, employers must provide fall protection if the distance from the walking/working surfaces to the water’s is 6 feet (1.8 m) or more.Is a USCG approved life vest acceptable at all height levels? At what height would fall protection be required, if at all? Q1: What are the requirements for fall protection over the water?Ī.
Subject: Working over Water and Ladder Safety I reached out to Chris and provided information and feedback regarding his questions: The employees should always be working with non conductive tools, preferably rubber or hard plastic along with wearing safety glasses or a face shield when working with electrical hazards. Fire resistant clothing is special clothing outside of the normal work wear, some shirts will list their ARC rating on the tags. while a 2 rating would require them to be wearing fire resistant clothing with an ARC flash rating of a 8. A 0 rating would require the employees to be wearing non-insulated clothes, safety glasses, etc. With the box being rated at 480 volts, this falls under categories 0-2.
The other information needed is what parts of the electrical box they are working on. You stated employees are working with 480 volts, that is part of the information needed. The higher the category number the more personal protective equipment is required. The National Fire Protection Agency (NFPA) classifies electrical work in categories from 0 to 4.
#Osha standard for a crane lift man basket how to#
In this standard it covers the design, training, and machine requirements. ANSI’s standard regarding mounted man baskets on forklifts is B56.6. However companies must abide by The American National Standards Institute (ANSI). A: There is not an actual general industry standard concerning mounted man baskets on forklifts.